Manual

  • Find a plane as straight as possible to install the hot tub, place wheel chocks.
  • Lower the support wheel down the front end of the trolley so that the tracks are at the same time position as in the picture. (The stories are on the cart by the oven.) Picture of the level bubble up
  • Install the rear struts on the trolley.
    Sequence: The plywood boards go on and on the ground support posts. The upper ends of the support posts are located under the trolley to the support beam at the location marked in orange.
    1
  • Turn the front end of the trolley upwards and install the front ones support posts.
    Sequence: The plywood boards go on and on the ground support posts. The upper ends of the support posts are located under the trolley to the support beam at the location marked in orange.
    2
  • Turn the support wheel up so that the trailer rests on the support posts, For safety reasons, leave the support wheel ~ 5cm above the ground when there is a space of ~ 1 cm between the rear struts and the trailer, then this is perfectly normal - the weight of the water itself will push the trailer soon support posts.
    MAKE SURE THE TROLLEY IS LEVEL.
    3
  • First, make sure that there is a drain ladder (with a chain at the bottom of the hot tub) closed. Start filling the hot tub with water.
  • WHEN THE WATER IS IN THE BATH, IT MUST NOT BE MOVED. RISK OF FRAME CURVED. (If you need to move the hot tub, empty it of water and start from the first point.)
  • IF THE UPPER PIPE IS INSIDE THE BATHTUB, YOU CAN START HEATING IF YOU DO IT EARLIER BURNS THE OVEN. (STRICTLY FORBIDDEN)
  • Install a chimney on the oven and start heating. Suitable for heating firewood only.
  • The hot tub heats up faster if it is kept on top of and occasionally mix water with a paddle.
  • After use, empty the hot tub oven of ash. Watch that ash would definitely be extinguished.
  • Only then can you drain the water from the hot tub. Hot tub to empty, remove the plug with a chain from the bottom.
  • To empty the oven, unscrew the oven drain plug (under the oven, unscrew a little and pull). Emptying the oven is especially important in minus degrees, otherwise in case the water freezes, the oven will break!